Before starting, switch off the kettle, unplug it and let it cool completely; cleaning a hot or plugged‑in kettle can be hazardous.
Remove the kettle from its base, place it on a stable surface near the sink and pour out any water that remains inside.
Inspect the interior for limescale, mineral deposits or stains that may have built up around the bottom and sides.
Mix equal parts white vinegar and water – for a typical kettle, two cups of each work well – and pour the solution into the kettle until the affected areas are covered.
Let the vinegar‑water mixture sit for 20 to 30 minutes; the acidity loosens mineral buildup, and longer soaking is possible if the kettle has heavy scale, provided the manufacturer allows it.
If the kettle’s care instructions permit, switch it on to bring the solution to a boil, then turn it off and allow it to cool; boiling can help dissolve stubborn deposits but should be avoided when the manufacturer advises against it.
Discard the solution, then rinse the interior several times with clean water, using a soft sponge or non‑abrasive cloth if needed; avoid steel wool or harsh chemicals that could scratch the kettle.
Wipe the outside with a damp microfiber cloth and a little mild dishwashing soap, then dry it thoroughly; never immerse the kettle, its base, cord or electrical connections in water.
If a vinegar odor remains, fill the kettle with fresh water, bring it to a boil and discard the water; repeat until the smell disappears, or let the lid stay open to air out.
For models with a removable filter, take it out, rinse under running water and gently brush away any deposits before reinstalling; finally, ensure the kettle is completely dry before placing it back on its base.
Comments